SpeedBox 3.0 for Flyon - Package: BOX, Qty: 10 pcs + 1 free

star 1 star 2 star 3 star 4 star 5(4)Rating value is 5 of 5
Specify product selection
Variant does not exist
BOX

$ 2260
In Stock
pcs

PROPERTIES:
Display shows: actual values
Maximum speed: unlimited
Speed limit setting: YES
Activation: by switching between two modes (→ ← → ←)
Display shows: actual values
Compatible with: motors TQ HPR120S
Not compatible with: SpeedBox App
More

Product code: SB3_F_10+1pcs_BOX Shipping and Payment

A smart chip of the third generation for Haibike FLYON model line

SpeedBox 3.0 tuning chip enables to select speed limit of your own choice. After the chip is installed, your e-bike’s display will show real data, such as maximum and average speeds, daily mileage and cruising range.

How does SpeedBox 3.0 work?

The tuning chip can be activated via the e-bike‘s control unit. To activate or deactivate tuning, use the → ← → ← button sequence in order to switch between two assistance modes twice. The actual speed limit will briefly appear on your display and the motor will support you up to this speed.

To deactivate the tuning kit, use the → ← → ← button sequence again. The value of cadence of 25 rpm will appear on your display and the speed limit will reset to 25 km/h. Your e-bike will then work the same as before installation of the chip.

You can set the maximum speed of an electric assistance by changing the following modes gradually: EXTREME - HIGH - MID - LOW - MID - HIGH - EXTREME. An actual speed limit will be displayed after that. The maximum speed of an electric assistance can be switched by turning the rear wheel about 180°. The cadence of 15 rpm on the display corresponds with the limit of 15 km/h, 20 rpm corresponds with the limit of 20 km/h, 25 rpm corresponds with 25 km/h, 30 rpm corresponds with 30 km/h, 99 rpm corresponds with 99 km/h etc. The last displayed limit will be saved after 5 seconds of inactivity.

Assembly

SpeedBox uses original connectors, therefore the installation of the chip to your e-bike is very easy. We have prepared detailed instructions and videos to make installation easy for you. Disassembly of our tuning chip is just as easy. If you have any troubles with installation or disassembly, do not hesitate to contact us.

If you are planning to install SpeedBox on a brand-new bike, make sure you ride it for at least 10 km before the chip is activated.

Detailed installation information can be found here

Warning

Please note that the operation of this type of modified electric bikes on public roads may be against the law in some countries. The manufacturer takes no responsibility for damages resulting from the use SpeedBox products. Electric bikes equipped with SpeedBox products are not allowed to be used on public roads, cycling paths and public places. Electric bikes equipped with SpeedBox products can be used exclusively on private property and entirely at one’s own risk. The use of SpeedBox may void the warranty of your ebike.

We strongly recommend using other safety features and protective gear to prevent injuries.

Bluetooth/ SpeedBox App NO